Ender 5 Plus Bed

The Ender 5 Plus Magbed is machined out of 9mm thick 5083 Aluminum Cast Tooling plate. We make these beds to order, so please leave 3-5 business days to get them shipped once your order is placed.

We check each bed on a granite surface plate to make sure it is within specs for use on your printer.

All beds have been checked to be under 0.2mm overall flatness.

Our magnets are 150C rated, with 11 lbs of holding force.

We recommend Subtle Design or Buildtak Flex Plates.

IMPORTANT NOTE: If at any point you decide to remove the magnets, first of all, when reinstalling the screws, turn the screw backwards until you feel the threads in the screw jump the threads in the bed. Once you feel that little bump, turn the screw in until it gets to the "screw stops turning point" with zero strength behind it. Once the screw has stopped turning, tighten it 1/32nd of a turn and NO MORE. Overtightening WILL shatter the magnets.

• Weight: 10 lbs (approx)
• Length: 377mm
• Height: 370mm
• Thickness: 9.5mm